Since proper fit is important for the comfort of the person wearing headgear, measurements should be determined by professional personnel.
Measure the head circumference (A) at eyebrow level. Occipital measurement (B) is taken from eyebrow level to the back of the head at the point that the helmet is to end. Over the top of the Head (C) to top of ears.
If for some reason the measurements do not fall within the above guidelines, or if there are other considerations to be taken into account, please contact rfq@rehabmart.com with A B C measurements to receive a quote on a custom helmet.
HEADGEAR SELECTION
Some suggested considerations to use in helping to determine what type of helmet would be suitable for your client.
IMPORTANT
While we believe that headgear can substantially reduce the risk of head injury we emphasize that there is no known device for preventing all injuries. Only you the customer are in a position to evaluate the particularized needs of the individual client in each environment. It is essential that professional and medical expertise be utilized in rendering decisions regarding headgear use.
(DMP-9821) Hard Shell Helmet with Blue Liner |
(DMP-9821) Hard Shell Helmet with Casa Tan Liner |
COLORS SHOWN BELOW ARE FOR THE LINER ONLY- IF A BLACK SHELL HELMET IS DESIRED PLEASE CLICK HERE |
Colors
Helmet Modifications:
MODEL 3469 - QUICK RELEASE BUCKLE CHIN STRAP Use in place of a regular chin strap when frequent attempts to remove the helmet occur. To release, just squeeze the buckle. SPECIFY:
or
|
MODEL 3467 - REINFORCED SEAMS Reinforced vinyl material is bonded into our foam liner seams, giving extra strength in these areas for situations where they receive exceptional stress. |
MODEL 3472 - HELMET CUSTOM STRAPPING SYSTEM Ideal for those situations where there are attempts to remove the helmet at inappropriate times. Straps are attached to each side of the 9821 Helmet (or to the bottom of the face guard on a 9822 Helmet) and then cross comfortably under the chin, attaching to the back of the helmet with quick release buckles. This also can be attached to our Model 9820 Soft Shell Helmet. |
MODEL 3470 - EYE GLASS RELIEF AREA Most clients who wear glasses are very comfortable wearing helmets with out this modification, but if eyeglass frames are a problem this solution is offered. Specially constructed padded polypropylene slings are formed to allow extra room for the frames of eye glasses. |
MODEL 3468 - FOAM VISOR
A thick 2" foam visor extends from the helmet approximately 3", and absorbs impact from bumps to the frontal area of the head. Closed cell foam with vinyl coating retains its compression resistance. This can be used in conjunction with the Face Bar when face forward impact is probable.
MODEL 3466 - FOAM REINFORCEMENT Reinforced vinyl material is bonded to our full helmet liner to prolong the life of the helmet. Especially good in situations when receiving particularly hard use. |
MODEL 3459 - HARD SHELL EAR COVERINGS An inside layer of soft ventilated foam and an outer covering of tough polycarbonate are attached to a Hard Shell Helmet covering the ear area. These can be purchased with a new helmet or they can be attached to an older helmet. Instructions are included. Specify helmet size and color when placing order. Sold per pair. |
MODEL 3465 - REAR HARD SHELL EXTENSION
In order to provide additional coverage at the back of the head, the polyethylene shell may be extended to cover the lower foam at the back of the helmet.